Emtech Electronics BLU-CIF - Manual (Page 2)

2
BLU- CIF RJ-45 CONNECTIONS
TOP ROW BLU-CP1 BLU-CC1A BLU-SV2 BLU-IR2
BTTM ROW BLU-CS/SV1 BLU-CC1B BLU-IR1 BLU-IR3
IMPORTANT: If you use the RJ-45 block for connecting the BLU-CC,
BLU-CP, BLU-CS, BLU-IR and BLU-SV(8), then do not use any of the
3.5mm euro-style connectors for these accessories. If you are using the
BLU-IR Infrared Sensors for combining audio in overflow areas, then you
have a choice to use either the RJ-45 connections in this block or the 3.5mm
euro-style connectors. Wiring the BLU-IR Infrared Sensors into the 3.5mm
connectors will be covered later on in this document.
A legend for the BLU-CIF RJ-45 connections has been silkscreened on the
Interface Board next to the corresponding block of connectors.
BLU-CIF 3.5mm Euro-block Wiring Instructions
The 3.5mm euro-block connectors have been provided for easy installation
of the BSS Audio equipment into older buildings with existing analog
wiring. Connectors for the BLU-CC, BLU-CP, BLU-CS and BLU-SV have
8-pins, and are located behind the RJ-45 block on the top half of the board.
On the left side of the
BLU-CIF Interface
Board is a 2 X 4 block
of RJ-45 connectors
for terminating the
BLU products via
Cat5e wiring. The
BLU products connect
in this order (left to
right):