Emtech Electronics BLU-CC - Manual (Page 2)

In addition to adding a 3.5mm stereo jack to the AUX Inputs section of the
BLU-CC2, there is a switch on the upper back of the board for setting up the
BLU-CC2 in either Mode 1 for a system using a new BLU-CIF/BLU-CIF2,
or Mode 2 for a system using an old BLU-CIF.
Backside of BLU-CC
MODE 1 PIN OUTS
CC1
RJ-45 Pin outs (has LED indicator)
1. Source (Logic Input)
2. Volume 1 (Logic Input)
3. Ref Voltage (+4.3V)
4. Not Used
5. VCC
6. Power Enable
7. SIG GND (C)
8. PWR GND (C)
1 8
CC2 RJ-45 Pin outs
1. Volume 2 (Logic Input)
2. Volume 3 (Logic Input)
3. Ref Voltage (+4.3V)
4. reserved for Mode 2
5. Not Used
6. reserved for Mode 2
7. SIG GND
8. PWR GND
Mic 3/Aux Output Connector (see next page)
(Key on bottom)
-IMPORTANT-
Setting up a BLU-CC2 in
Mode 1 in conjunction with a
new BLU-CIF or BLU-CIF2
requires a new template, which
is available from BSS Audio.