Elite Screens ezFrame Plus Series - Manual (Page 6)

6
Rev.091912-JA
www.elitescreens.com [email protected]
Attaching the Fix Plates ___
1. Make sure that the material and frame are both lying face down on a clean, dry and non-abrasive surface.
2. Center the material inside the frame.
Please note that the material will be noticeably smaller than the frame. The size differential is needed in order to
be able to stretch the material as you attach it to the frame so that the end result is a flat viewing surface.
3. Start by attaching the fix plates in the center of the long horizontal frame (1), then alternate with the center
short sides (2) as shown in the diagram below (fig.7).
Note: Follow these instructions to make sure the material is properly fixed in the center position of the frame. After
attaching the fix plates in sequence# 2 (the center of the short sides), please remove the fix plates in sequence #1(the
center of the long horizontal edge) and reattach them again, and also remove the fix plates on sequence# 2 and
reattach them again.
4. Then continue to follow our recommended order (numbers 3-8) to properly distribute tension to the screen
material.
Center Support Bar d
1. Insert the support joiner into each end of the center support bar to complete assembly.
support joiner
Center support bar
2. Insert the Center Support Bar into the upper top groove on the back of the frame (not the one where the fix
plate inserts) with the bottom end near the approximate center point of the frame and rotate it in at an angle so that
both ends of the bar are in alignment with the groove.(see Fig. 8 below for details).
支
(Fig. 7)