Electronics International UBG-16 User Manual

Page 23

1. Enter the Power-up Programming Mode:

With the power to the UBG off, press and hold the Mode Switch to the left. Continue to hold the Mode
Switch to the left and turn the power to the UBG on. After the UBG performs a self test, “PROGRAM”
will appear in the digital display. Release the Mode Switch.

2. Configuring EGT and CHT Channels:

The digital display will indicate “EGT 1-X”. The number blink-
ing (“X”) in the right portion of the digital display is the last EGT
and CHT channel monitored. Left channels are used to monitor
EGTs and right channels are use to monitor CHTs. EGTs and
CHTs will be displayed in the columns of bars.

Use the Step Switch to set the number of EGT's and CHT's to be
monitored.

3. Configuring the 7th Column of Bars:

Push the Mode Switch to the right. The digital display will
indicate “BAR7 XXX”, providing the 7th column of bars has not
been used to monitor a 7th EGT channel. (Note: a blinking
“XXX” in the display = “OFF” or “TIT” or “OIL”.) Use the Step
Switch to set the 7th column of bars to indicate either TIT, Oil
Temp or to turn the 7th column OFF.

TIT or Oil Temperature can be displayed only on the 7

column of

bars. However, the TIT or Oil Temperature probe represented by
the 7

column of bars must be connected to the next available

input channel after the last EGT channel on the left circular
connector. Example: If configuring the UBG to monitor 4 EGTs
and 4 CHTs and Oil Temperature, the 7

column of bars will

display Oil Temperature, although that probe must be connected to the 5

input channel on the left circular

connector.