Teledyne 3300PB - Low cost percent oxygen analyzer - Manual (Page 24)

3 Installation Model 3300 PB
3-8
Teledyne Analytical Instruments
3.5 Installation Checklist
Before connecting the instrument to the power source and turning it on,
make sure you have:
• Correctly installed the Sample and Exhaust gas lines
• Opened the isolation valves
• Checked for leaks
• Set the sample pressure to 5–10 psig (34.5-68.9 Kpa), nominal
(for non-vacuum service units)
• Set the flow
Once the above checks have been made, you can connect to the power
source. The instrument is now ready for operation.