SPP Pumps Eurostream - Manual (Page 3)

Operators Instructions for
Eurostream Centrifugal Pumps
Manual No/Rev
W22-001E / 9
Our policy is one of continuous improvement and we reserve the right to alter specifications at any time
Page 3 of 20
CONTENTS
Section Page
1. General Information & Safety Instructions 3
2. Transport Handling and Storage 4
3. General Description 4
4. Assembly and Installation 5
5. Commissioning and Operation 6
6. Maintenance and Service 6
7. Faults and Remedial Action 11
8. Pump Details: 13
8.1 Pump Dimensions and Weights 13
8.2 Pump Connections 13
8.3 Cross Section Drawings 14
8.4 Parts Identification List 16
9. Additional Information 17
10. Spares and Service 20
Manufacturers Information:
(Where applicable)
Electric Motor
Appendix I
Introduction
This manual gives the safety, installation, operation
and maintenance instructions for pumps in the SPP
Pumps EUROSTREAM range of close-coupled
horizontal, end suction, centrifugal pumps for
general and industrial use
Eurostream pumps are identified by their size code,
the first number is the delivery branch diameter and
the second number is the nominal diameter of the
impeller in centimetres.
The pump sizes covered by this manual are:
32/13 32/16 32/20 32/26 -
40/13 40/16 40/20 40/26 -
50/13 50/16 50/20 50/26 -
65/13 65/16 65/20 65/26 65/32
- 80/16 80/20 80/26 80/32
- - 100/20 100/26 100/32
- - - 125/26 -
(Clamped Casing
Cover)
(Bolted Casing
Cover)
Eurostream pumps share common components
with the SPP Pumps Unistream range of long
coupled pumps.
1. General Information and
Safety Instructions
The products supplied by SPP Pumps Ltd. have
been designed with safety in mind. Where hazards
cannot be eliminated, the risk has been minimised
by the use of guards and other design features.
Some hazards cannot be guarded against and the
instructions below MUST BE COMPLIED WITH for
safe operation. These instructions cannot cover all
circumstances; YOU are responsible for using safe
working practices at all times.
1.1 SPP Pumps products are designed for
installation in designated areas, which are to
be kept clean and free of obstructions that
may restrict safe access to the controls and
maintenance access points.
A pump nameplate is fitted to each unit and
must not be removed. Loss of this plate
could make identification impossible. This in
turn could affect safety and cause difficulty in
obtaining spare parts. Should accidental loss
or damage occur, contact SPP Pumps Ltd.
immediately.
1.2 Access to the equipment should be
restricted to the personnel responsible for
installation, operation and maintenance and
they must be trained, adequately qualified
and supplied with the appropriate tools for
their respective tasks.
1.3 SPP Pumps Ltd. requires that all personnel
that are responsible for installation, operation
or maintenance of the equipment, have
access to and study the product instruction
manual BEFORE any work is done and that
they will comply with all local and industry
based safety instructions and regulations.
1.4 Ear defenders should be worn where the
specified equipment noise level exceeds
locally defined safe levels. Safety glasses or
goggles should be worn where working with
pressurised
systems and hazardous
substances. Other personal protection
equipment must be worn where local rules
apply.
1.5
Do NOT wear loose or frayed clothing or
jewellery that could catch on the controls or
become trapped in the equipment.
1.6 Check and confirm that the manual is the
relevant copy by comparing the serial
number on the identification plate with that
on the manual.