American Dryer Corp. AD-115 - Manual (Page 35)

33
Telephone: (508) 678-9000 Fax: (508) 678-9447
Blower Motor Mount Assembly
for Steam Models ONLY
Illus. No. Part No. Qty. Description
13 100706 1 5/16” x 5/16” x 1-3/8” Key
14 317400 1 Impellor (fan) Shaft
15 100802 2 1-3/8” Retaining Ring
16 880879 2 1-3/8” Pillow Block Bearing with Set Screws and Grease Fitting
154326 4 5/16 x 3/8” Allen Set Screw ONLY
170511 2 1/8-27 N.P.T. Grease Fitting ONLY
17 153004 4 3/8” Flat Washer
18 153005 4 3/8” Lock Washer
19 150601 4 3/8-16 x 2” Hex Head Machine Bolt
20 850480 1 Blower Motor Mount ONLY
820383** 1 Motor Mount Assembly Complete
(includes illus. nos. 1 through 20 and 24 through 32)
For 60 Hz Models ONLY
820253 1 Motor Mount Assembly Complete
(includes illus. nos. 1 through 20 and 24 through 32)
For 220v 50 Hz Models ONLY
820384** 1 Motor Mount Assembly Complete
(includes illus. nos. 1 through 20 and 24 through 32)
For 380/416v 50 Hz Models ONLY
21 152005 8 3/8-16 Hex Nut
22 153005 8 3/8” Lock Washer
23 153004 8 3/8” Flat Washer
24 150609 2 1/2-13 x 4-1/2” Hex Head Machine Bolt
25 152011 2 1/2-13 Hex Nut
26 117600 4 Noise Suppressor Tape (sold by the foot)
27 100603 1 16” Impellor with 3/4” Bore
28 100714 1 3/16” x 3/16” x 1-7/8” Key
29 153050 1 1/2” Flat Washer
30 152006 2 1/2-20 Left Hand Jam Nut
31 820379 1 Blower Motor Mount Belt Guard
32 150309 4 #10-16 x 1/2” Hex Head TEK Crimptite Screw
* Replace in matched sets (both belts).
** Specify voltage when ordering.
IMPORTANT: For voltages higher than 460 VAC - 50 Hz, contact the factory for correct part number of
motor or motor mount assembly.