Bosch KSW38940 Cave à vin de vieillissement Premium Luxe - Manual (Page 21)

21
Aligning the appliance
Place the appliance in the designated
location and align.
Adjust the height-adjustable feet with
a screwdriver.
Connecting
the appliance
After installing the appliance, wait at least
1 hour until the appliance starts up.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for
the first time, clean the interior of the
appliance (see chapter Cleaning).
The socket should be freely accessible.
Connect the appliance only to
220–240 V/50 Hz alternating current via
a correctly installed earthed socket.
The socket must be fused with a 10 A
to 16 A fuse.
If the appliance is to be operated in
a non-European country, check on
the rating plate whether the indicated
voltage and current type correspond
to the values of your mains supply.
The rating plate is situated in the bottom
left-hand side of the appliance.
The power cord may be replaced by
a technician only.
!
Warning
Never connect the appliance to electronic
energy saver plugs or to power inverters
which convert the direct current to 230 V
alternating current (e.g. solar equipment,
power supplies on ships).
Switching on
the appliance
Press the main switch, Fig. 1/1.
The appliance starts refrigerating.
The factory has preset the upper chilling
zone with a basic setting of +18 °C and
the lower chilling zone with a basic
setting of +10 °C.
Selecting the
temperature
The set values can be changed,
see Description of control panel.
Using the thermometer
Fig. 5
Activate the digital thermometer:
S Insert batteries into the rear of the
thermometer. The temperature is
displayed in ºC.
en