Asus P5A - Manual (Page 30)

30 ASUS P5A User’s Manual
III. INSTALLATION
Connectors
III. INST
ALLA
TION
13. CPU Cooling Fan Connectors (FAN, 3 pins)
These connectors support 3-pin cooling fans of 500mA (6W) or less with a mini-
mum of 3,500RPM. Orientate the fans so that the heatsink fins allow airflow to
go across the onboard heatsink(s) instead of the expansion slots. Depending on
the fan manufacturer, the wiring and plug may be different. The red wire should
be positive, while the black should be ground. Connect the fan’s plug to the
board taking into consideration the polarity of the connector. NOTE: The “Ro-
tation” signal is to be used only by a specially designed fan with rotation
signal. The Rotations per Minute (RPM) can be monitored using ASUS PC
Probe Utility or Intel LDCM Utility.
WARNING! The CPU and/or motherboard will overheat if there is no airflow
across the CPU. Damage may occur to the motherboard and/or the CPU fan if
these pins are incorrectly used. These are not jumpers, do not place jumper
caps over these pins.
P5A 12Volt Cooling Fan Power
CPU Fan Power
GND Rotation +12V
GND Rotation +12V
R
GND
Rotation
+12V
Chassis Fan Power
Power Supply Fan
14. IrDA-Compliant Infrared Module Connector (IR, 5-pin block)
This connector supports the optional wireless transmitting and receiving infra-
red module. This module mounts to a small opening on system cases that sup-
port this feature. You must also configure the setting through UART2 Use Infra-
red in Chipset Features Setup to select whether UART2 is directed for use
with COM2 or IrDA. Use the five pins as shown below (Back View) and con-
nect a ribbon cable from the module to the motherboard according to the pin
definitions.