The init button – PROLiNK PPS2104N User Manual User Manual
Page 32
EN 29
10. The Init Button
The Init button is used for maintenance: Simultaneously press Init button and turn on (by plugging in the power
adaptor) the Server until USB1 and USB2 LED indicators simultaneously blinks. (For PPS2101/PPS2101N, only USB LED
indicator will blink.) After that, the Server will do the following tasks:
a) Perform a Factory Default restoration of the server, which will restore most of the parameters and settings to
factory default values.
b) Perform a TFTP server. You can upgrade new firmware using any TFTP client tool.
Note:
After performing the tasks mentioned above, you have to plug off the power adaptor and then plug in the power adaptor
to restart the Server.
This manual is related to the following products: