Acer 3300S - Manual (Page 45)

39 Chapter 2
Video Off Option This item is to control the mode in which the
monitor will shut down.
Always On: Always keep the monitor on.
Suspend --> Off: During suspend mode, the
monitorwill shut down. Susp, Stby --> During
suspend or standby mode, the monitor will shut
down. All Modes --> Off: The monitor is turned
off during doze, standby or suspend mode. Always On
Suspend Off
Susp, Stby --> Off
All Modes
Video Off Method This item determines the manner in which the
monitor is blanked.
V/H SYNC+Blank: This selection will cause the
system to turn off the vertical and horizontal
synchronization ports and write blanks to the
video buffer. Blank Screen: This option only
write blanks to the video buffer. DPMS
Supported: Initial display power management
signaling. V/H SYNC+Blank
Blank Screen
DPMS Supported
Modem Use IRQ This setting names the interrupt request (IRQ)
line assigned to the modem (if any) on your
system. Activity of selected IRQ always
awakens the system. 3, 4, 5, 7, 9, 10, 11, AUTO.
HDD Power Down If HDD activity is not detected for the length of
time specified in this field, the hard disk drive will
be powered down while all other devices remain
active. Disabled
1~15 Mins
Soft-off by PWR-BTTN This feature allows users to configure the power
button function. Instant Off: The power button
functions as a normal power-
on/-off button.
Delay 4 Sec: When you press
the power button, the
computer enters the suspend/
sleep mode, but if the button is
pressed for more than four
seconds, the computer will be
turned off.
Aftrer PC Power Lost This item specifies when your system reboot
after a power failure or interrupt occurs. Power Off
Power On
Last State
Power On by Ring When enabled, any fax/modem activity wakes up
the system from suspend mode. Disabled
Enabled
Wake-Up by PCI Card Use PCI Wake-up system. PCI must meet PCI
2.2 specification. Disabled
Enabled
Resume by Alarm Use this option to set the date and time for your
computer to boot up.
Date (of month) Alarm* - Indicate the month for
system to boot up. Set it to 0 if you want to boot
up everyday.
Time (hh:mm:ss) Alarm* - Indicate the hour,
minute and second for system to boot up. Disabled
Enabled
*Set Resume by Alarm to
Enable, then press “Enter” to
show the range of Date and
Time Alarm.
Parameter Description Options