Poweramp TPR SERIES - Manual (Page 32)

30 4111-0035 — Feb 2012
Aug 2012
TROUBLESHOOTING
• Set multimeter to “RX1” scale for
“Continuity Test”.
• Attach multimeter leads to pins “B”
and “C” of limit switch connector. You
should have: -plunger released - no
metre reading -plunger depressed - a
“Full Scale” meter reading
NOTE: The green (ground) wire of the
limit switch does not have to be tested. A
continuity test lamp may be used instead
of a multimeter.
LIMIT SWITCH TEST PROCEDURE