Poweramp LHP SERIES HYDRAULIC - Manual (Page 24)

22 4111-0012 — Aug 2012
April 2013
OPERATION
End Loading/Unloading — Platform at Cross-Traffic
Position.
End Loading/Unloading — Platform at Below-Dock Position.
4. If transport vehicle bed is at or above dock floor
level, leave leveler at the cross-traffic position and
proceed with loading or unloading.
NOTE: If ramp loading is required, see Ramp
Loading/Unloading Instructions on page 21.
End loading or unloading can be done with
the dock at the cross-traffic position or
below-dock position, depending on the height
of the transport vehicle bed.
1. Check to make sure transport vehicle is positioned
squarely against dock bumpers.
2. Instruct driver to remain at the dock until the
loading or unloading process has been completed.
3. Chock the transport vehicle wheels or use the
truck restraint if available.
End Loading/Unloading Instructions
5. Push the Raise button (A) to the platform just
enough to clear the lip keepers.
6. Proceed with loading or unloading.
NOTE: When end unloading is finished and access
to the rest of the transport vehicle is still
required, the platform lip will need to be
extended. See Ramp Loading/Unloading
Instructions on page 21 for further
instructions.
7. When the loading or unloading is finished, return
the dock leveler platform to the cross-traffic
(stored) position by performing one of the
following:
OR
• Push the Raise button (A) until the lip clears the
lip keepers. Release Raise button, leveler will
return to the stored or cross traffic position.
8. Remove chocks from transport vehicle wheels or
release the truck restraint if used.
9. Indicate to the driver that the truck may leave the
dock.
Operating Instructions—Continued
A