Ontents, Rror, Messages – Avery ALS 256 User Manual
Page 55

51
C
ONTENTS
6.1 E
RROR
MESSAGES
ALS
20x
256
GB
5026
MotorProtect CPU
– (ALS 256) Dust filter liner exhausted.
This leads to overheating the ma-
chine.
– (ALS 20X) Voltage selection switch
set faulty.
– There are some more possible caus-
es, which require a qualified service
technician to cure.
£
Renew the dust filter liner.
£
Check setting of the voltage selectio-
in switch.
£
If none of the above listed actions is
successful, search for technical as-
sistance.
5140
Rewinder control
Rewinder control
During problem-free operation,
the rewind unit dancer arm only
moves a minimal distance
around the "control position".
This is the position the dancer
arm takes up after initialisation
of the machine.
– Any force applied that moves the
dancer arm from its control position.
Example: The feed motor is blocked;
the backing paper is not conveyed
quickly enough; as a result the
dancer arm is pulled upwards.
Example: The backing paper is torn;
the dancer arm springs downwards.
£
Press the
key.
– This reinitialises the dancer arm con-
trol; the dancer arm moves back into
the control position.
5143
Rewinder Stop
– This message appears when the
dancer arm was held against its up-
per stop for more than two seconds.
Effect:
Power to the rewinder motor is
switched off, so that the rewinder can
be turned easily by hand.
This effect is helpful when in-
stalling a new label roll, because
the rewinder can be turned
easily.
£
Press the
key to confirm the er-
ror message.
5145
Material feed
The maximum permitted diameter
(205 mm) for the rewinder roll has been
reached.
£
Remove the rewound backing paper
This error can only occur if the
end of a new label roll was glued
on to backing paper that had al-
ready been wound onto the re-
winder.
£
Press the
key to confirm the er-
ror message.
Status
Status text
Cause
Action to take
[53]
List of error messages