2 inserting a label roll, Removing spent backing paper, Removing glue residue – Avery ALS 256 User Manual
Page 37: Inserting a new label roll

33
C
ONTENTS
3.2 I
NSERTING
LABEL
MATERIAL
ALS
20x
256
GB
3.2.2
Inserting a label roll
WARNING!
Risk of injury due to moving and rapidly
rotating parts!
£
Before inserting the label roll, ensure that
the device is turned off at the main
switch.
£
Do not under any circumstances turn the
device on before the label strip is
threaded in completely.
Removing spent backing paper
Assuming backing paper has gathered on the rewinder
[32A] :
£
Press the release button [32B].
– The tensioning mechanism of the rewinder is
slackened.
£
Remove the rewound backing paper.
Removing glue residue
£
If necessary, clean the following components:
– Dispensing plate
– Deflection rollers
– Drive rollers
– Pressure roller
£
Follow the directions provided in section
“Maintenance and cleaning” on page 47.
Inserting a new label roll
£
Push the material roll [33A] onto the unwinder as far
as it will go.
£
Rotate the rotary knob [33B] in a clockwise direction
until the label roll sits tightly.
£
Run the label strip around the dancer arm as shown
in the figure [33C].
[32] A Rewound backing paper
B Release button
C Backing paper path
B
A
[33] Inserting the material roll – Part 1.
A
C
B