‘hotkeys’ and they signal to the AdderView CATxIP 5000 that you wish to
control it, rather than the computer. However, if these particular hotkeys
clash with another device or program, then your administrator may change
them to a different combination. If the

combination fails to work,

then please contact the system administrator for details.
Note: VNC hotkeys are set separately to the hotkeys used by the locally
connected keyboard. For details about changing the VNC Viewer hotkeys,
see

Appendix 2: Unit Configuration

2 While still holding

and

, press the first numeral of the required port

address, then:

• If the port address is a single character, release all of the keys.
• If the port address is two or more characters, release the first numeral

key and press the second – repeat this procedure until all of the port
address numerals have been entered, then release

and

Note: The numbers on your keyboard’s numeric keypad are not valid, use
only the numeral keys above the QWERTY section.
Note: If you do not have authorisation to view the selected port then a
message will be displayed to explain your lack of access rights.
Note: When using hotkeys, the leading zeros for all single digit port
numbers (including all cascade levels) are optional, i.e. 01, 02...09.

Standard hotkeys
The range of hotkey combinations are as follows:
Note: If your hotkeys have been changed, substitute them for

and

the examples given here.

Selects port 1

Selects port 2

•

then

Selects port 10

Note: When entering multiple digit addresses as
above, keep

and

pressed down until all

other numbers have been entered.

Selects no host

Displays the Host Selection menu so that you
may choose a host by name.