The AdderView CATxIP 5000 unit is powered
by the supplied 5V power adapter. There is no
on/off switch on the unit, so operation begins
as soon as a power adapter is connected.

2 Connect the IEC connector of the supplied country-specific power lead to

the socket of the power adapter.

3 Connect the power lead to a nearby main supply socket.

Note: Both the AdderView CATxIP 5000 and its power supply generate heat
when in operation and will become warm to the touch. Do not enclose them
or place them in locations where air cannot circulate to cool the equipment.
Do not operate the equipment in ambient temperatures exceeding 40 degrees
Centigrade. Do not place the products in contact with equipment whose surface
temperature exceeds 40 degrees Centigrade.

AdderView CATxIP

000 rear panel

output lead from

power adapter

POWER