Bosch THD2023 Heißwasserspender Filtrino FastCup - Manual (Page 19)

19
THD20.. 07/2011
en
Important: To keep the dispensed water
from overlowing, make sure that you place
a suficiently large glass or cup under the
water outlet.
Note: To change this setting at any time,
repeat the above procedure.
Child lock
For safety reasons, this appliance is
equipped with a child lock. To activate it,
proceed as follows:
► Press and hold the temp. set and start/
stop buttons simultaneously for at least
5 seconds. The L and P icons light up .
Info: When the child lock is activated, only
room-temperature water is available. When
you press the temp. set button, the L
lashes; all other settings are blocked.
To deactivate the child lock, proceed as
follows:
► Press and hold the temp. set and start/
stop buttons simultaneously for at least
5 seconds. The P icon goes out.
BRITA MAXTRA water
ilter system
In models equipped with a water ilter
system, only BRITA MAXTRA water
ilter cartridges may be used.
BRITA MAXTRA cartridges can be
purchased from retailers or directly from
Bosch Customer Service. (See the back
pages of these instructions for contact
information).
The appliance can be used with or without
a ilter cartridge.
Keep in mind that you will enjoy the bene its
of BRITA iltration only if a MAXTRA ilter
cartridge is installed in the appliance. Tea
and coffee also have more aroma when
prepared with fresh, BRITA-iltered water.
To use the machine without a ilter, simply
remove the ilter holder and the ilter
cartridge and adjust the machine settings
accordingly.
Important: The Filter Yes/No setting
controls the ilter replacement indicator as
well as the descale mode icon.
To change the Filter Yes/No setting,
proceed as follows:
► Turn the appliance off with the on/off
switch.
► Press and hold the temp. set button.
► Turn the appliance back on with the on/
off switch – the M icon lashes.
► Press the start/stop button to select
the Filter Yes/No setting:
Yes = M lights up
or
No = M does not light up
► Release the temp. set button – the
setting is now stored, and the most
recently selected temperature lights up.
Note: To change this setting at any time,
repeat the above procedure.
Important: If you have not used the
appliance for a longer period of time
(for example, after holiday), remove the
ilter and install it again after your return
following the steps as described in chapter
“Preparing and installing the BRITA
MAXTRA ilter cartridge”.
After setting the ilter to “yes”, the symbol M
will light after a certain time during opera-
tion. The BRITA MAXTRA ilter cartridge is
exhausted and needs to be changed.
Filtrino_H1_all_languages.indd 19 01.08.2011 10:52:08