Penn-Century MIP - Manual (Page 2)

To assemble:
1. Unscrew the screws attached to the end of the steel support bar (A) using the small hex
wrench provided.
2. Line up the holes on the steel support bar with those on the base of the platform, and
insert the screws up through the base into the
steel bar.
3. Tighten screws with hex wrench firmly, but not
with excessive force - until the top of the screw
is even with the surface.
4. The platform is designed to be attached to a
standard laboratory holder-clamp setup (
provided
not
the platform and bar angle as desired.
). Clamp the bar in place and position