Pach and Company AeGIS NPB7000P Series Manual - Manual (Page 22)

AeGISNPB7000P Page 22
2. Press 1= enable or 0= disable then press #
76
OPENNING DOOR BEEP OFF
1= enable (beep on)
0= disable (beep off)
Default is 1 (enable)
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 15
1. Enter function code 76 then press #
2. Press 1= enable or 0= disable then press #
77
PBX
Not Applicable
Not Applicable
78
VIEW DIRECTORY BY NAME
Directory number can be viewed if the tenant name is
programmed into the directory.
Tenant’s name will show in alphabetical order.
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 15
1. Enter function code 78 then press #, the
display will show as an example shown
2. Press
3- scroll A-Z
6- scroll Z-A
3. Press # to view the directory associated with
the tenant’s name.
4. Repeat step 2 to view next tenant’s directory.
91
TOTAL NUMBER OF TENANT DIRECTORY
Number of tenants are occupied the system memory
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 15
1. Enter function code 91 then press #
2. The display above is shown the total number
of tenant’s directory is 25
UnlockBeep (1,0) 1
WARNING: IF THE DIRECTORY IS
USED TO PROGRAM THE 4‐DIGIT ACCESS
CODE OR TELEPHONE NUMBER
WITHOUT
NAME , THEN FUNCTION CODE 78 WILL NOT
WORK
PACH AND COMPANY
DIR:001
Total TnT: 025