Nokta detectors Golden Sense User Manual User Manual
Page 18
NOKTA ENGINEERING
17
TURNING ON THE DEVICE AND SETTINGS
5cm
2
SENSITIVITY SETTING
Holding the search coil 5cm. above the ground, sweep it right and left.
If the detector emits false signals due to interference, reduce the sensitivity until the
signals go away and start searching.
SENSITIVITY
Sensitivity setting is used to eliminate interferences caused by electromagnetic waves in the surrounding environment.
Electromagnetic waves may result from power lines in the surrounding environment or from the operation of electrical
devices, radars, wireless radios, and even TVs.
Sensitivity is also the depth setting for the device. Therefore, it is recommended that you do not lower it too much suddenly
but gradually decrease it to determine the level where you are not getting any interference and continue searching.