Diamond Products CC1600 - Manual (Page 13)

Saw does not move
past track joints.
Tracks are not aligned.
Tracks are warped.
Saw rollers too tight.
Mount tracks
correctly, using jack
screws to correct
alignment.
Readjust rollers until
saw travels past joint
properly.
No water at blade. Water valve is shut.
Water hose not
connected properly.
Low water pressure.
Check water supply.
Check hose
connections.
Check water pressure
(min. 15 psi)
Poor cutting
performance.
Defective saw motor.
Blade is glazed.
Defective power unit.
Replace saw motor.
Dress blade.
Check power unit.
Loss of gear oil or
water present in
pivoting arm
Defective seals in
support blade guard
mount
Replace water seals