DefenderWorx H2 BUMPER LETTERS User Manual
Bumper letter insert installation instructions
BUMPER LETTER INSERT
INSTALLATION INSTRUCTIONS
Use an alcohol pad to clean the surface of the letters and plastic bumper where the tape will be
applied. Make sure all surfaces are smooth and dry before applying letters. Apply 3M Adhesion
promoter to the surface of the bumper where the letters will be applied. Allow surface to dry for 5
minutes. Remove the plastic film from the back of the letter you will be applying and then apply
letter to bumper and press firmly. Do not wash or allow the bumper to get wet for at least 48
hours.
NOTE; Do not allow the 3M Adhesion Promoter to get on any surface other than where the
letters will be placed.
Defenderworx, Inc.
1120 North Armando Avenue
Anaheim, CA 92806
(714) 630-9700 Phone
(714) 630-9701 FAX