DefenderWorx Front & Rear Bowties (Chrome / Black) - Manual

Replacement Bowtie Installation
Instructions
For both front and back bowtie make sure to clean surface with rubbing alcohol before applying
replacement bowties to the car.
Front Bowtie:
Reach both hands underneath the factory bowtie housing (whole chrome piece)
on each side. Feel around for the two clips on the back of the bowtie housing. Pull both of the
clips down and forcefully pull/wiggle the bowtie housing out. Flip over the housing and poke out
the gold bowtie through the back using a flat head screwdriver and the four holes on the back of
the bowtie housing unit. Clean the area and replace with the DefenderWorx Bowtie. Snap the
bowtie housing back into place on the grill and enjoy your new DefenderWorx Replacement
Bowtie.
Back Bowtie:
Take the largest size drill bit that you have and slowly begin to drill through the
middle of the factory gold bowtie. As you drill deeper eventually there will be white shavings
coming off of the gold bowtie. When you drill through the gold bowtie stop drilling and take a flat
head screw driver and/or a small pick device and pop out the factory bowtie threw the drilling in
the middle. After you have removed all of the existing gold factory bowtie, now take your new