DefenderWorx H2 HOOD LATCH User Manual
DefenderWorx Accessories communication
H2PPC05009 / H2PDC05009 HOOD LATCH
INSTALLATION INSTRUCTIONS
Remove the four 10MM nuts (two on each side of the hood) from inside the rubber stops located
on the inside of the hood. Install stainless studs in the anchor sections using an Allen wrench.
Place the rubber “bone” into the new parts pushing the pin partially out allowing it to be removed.
Insert the “bone” in the anchor and latch piece. This is intentionally a tight fit so the heavy latch
won’t rattle against the body when you close your hood. Bolt anchor back through rubber stops
and close the hood.
Defenderworx, Inc.
1120 North Armando Avenue
Anaheim, CA 92806
(714) 630-9700 Phone
(714) 630-9701 FAX