DefenderWorx Mustang Automatic Gear Shifters - Manual (Page 4)

Defenderworx, Inc. 1120 N. Armando Street, Anaheim, CA 92806 714.630.9700 Tech
www.defenderworx.com E-mail: [email protected]
Step 5: This is one of the final steps and you will have the factory knob ready to remove. This base is held
in with 4 clips at the base of the floor. It will pop out and underneath the shifter housing, you will find 2
wires that need to be unplugged. One set is black and read and the other is at the base of the shifters
shaft. You’ll have to get to the wires at the base of the shaft while holding this console base up slightly.
These wires are connected to the shift knob itself. Once unplugged, you can now remove the knob and
start the assembly of your Defenderworx shift knob onto the vehicle.
This is the clip that is at the base of
the housing on the floor. Please
make note of where any wires you
unplug and where they need to plug
back into. Ford has made it fairly
easy where the plugs are all different
and on our test unit, they were all
specific plugs. They couldn’t be
crossed on our test unit, however, we
are unsure of all production models.
Please note where your wires go to
insure it assembles back together
properly.