Multichannel Systems µPA16+32 Manual - Manual (Page 11)

7
3.2.2 ME/W-SG Test
The following screen shots show the results of a test with a ME/W-SG signal generator.
Please read the data sheet in the appendix.
Connect the ME/W-SG to the μPA32 via Omnetics connector on the bottom of the signal generator.
The Omnetics connector of the μPA is lettered in black and the Omnetics connector of the ME/W-SG
respectively. Please connect the devices in this way that the letters are on one side, facing to the bottom
of the ME/W-SG as shown on the picture.
Switch the dip switch into the desired position and press the control button to start the device. The
example below shows heart signals (ECG ventricle). The Portable ME32-System used for this test had
a total gain of 1000 and a bandwidth of 1 to 5000 Hz.