MIDLAND BT Rebel - Manual (Page 7)

7
E
n
g
li
s
h
manual supplied with your GPS Sat-Nav for further infor-
mation.
2. Ensure that the BT Rebel is in Setup mode (Red light on) &
Press the “Phone” button on the BT Rebel unit until the red
and blue indicators start to flash.
3. After a few seconds the GPS Sat-Nav will display “Midland
BT Single”. Select it and follow the instructions provided
in the GPS Sat-Nav manual to accept the pairing. When
prompted, enter the pairing code, which is 0000 (four ze-
roes).
The GPS should then display a confirmation message if
the pairing operation has been successfully completed.
4. The BT Rebel unit returns to the Setup mode (red indicator
permanently on) to indicate that it is ready to be paired with
other devices.
If you pair the BT Rebel unit with a GPS Sat-Nav, you will not
be able to pair it with a cell phone, because both these devices
are assigned (high) priority 1.
This problem can be easily solved by pairing the cell phone
directly with the GPS Sat-Nav and by then pairing your GPS
with the Midland BT Rebel. In this case, the cell phone featu-
res will be managed by the GPS Sat-Nav.
Attention: the device search procedure (red and blue
lights flashing) continues for approximately 2 minutes.
If no device is found within this interval of time, the BT
Rebel returns to the Setup mode (red light permanently
on). To start again the search, repeat the pairing proce-
dure from step 2. To cancel the pairing procedure (red
and blue indicators flashing) and return to the Setup
mode at any time, press “Music” button twice.
Resetting all paired devices
Sometimes you may find it necessary to delete all the pairing
references stored in the BT Rebel unit (reset operation).
To perform this operation, simultaneously press and hold
down the “Volume +” and “Volume –“ buttons for 4 seconds.
The Blue Light will be lit on for 1 sec.
This procedure deletes all the paired Bluetooth devices sto-
red in the memory and it is therefore possible to start a new
“clean” pairing session.
Exiting from the Setup mode
After you have paired the desired Bluetooth devices, you must
quit the “Setup” mode in order to be able to use your BT Re-
bel.Press and hold the Music button (central button) for 3 se-
conds.he red indicator switches off and the blue one starts to
flash. You can now use your BT Rebel.
Reconnecting the unit to bluetooth devices
After successfully pairing your devices, you can switch them
off and on without having the repeat the pairing procedure.
If a connection failure occurs between the two devices (for
example because one device is switched off or you are not
within the maximum range), it is not necessary to repeat the
pairing procedure.
Simply switch the device on again or move within the maxi-
mum range. If the connection cannot be re-established auto-
matically, select the device from the “devices menu” of your
Bluetooth device (for example mobile phone, GPS, etc…) and
re-enable the connection.
Adjusting the volume
Your Midland BT Rebel uses AGC technology, which automa-
tically adjusts the listening volume in relation to background
noise.
However, it is also possible to manually adjust the volume by
means of the “Volume+” and “Volume -“buttons.
For example, you can manually adjust the maximum volume
in very noisy environments (for example when travelling at
high speeds), to allow the AGC automatic system to change
the volume and use the manually set volume as maximum set-
ting. This operation is useful because each type and standard
of helmet is influenced in different ways by wind and back-
ground noise.