MIDLAND BT Rebel - Manual (Page 6)

6
Switching your Midland BT REBEL
on and off
BT Rebel can be switched on by means of the central button
labeled “Music”.
To switch off the unit you must use a combination of two but-
tons (Music+AUX), thus lessening the chances that you might
turn off the unit accidentally (especially whilst wearing heavy
gloves).
Switching the unit on:
› Press and hold “Music” button down for approximately 3
seconds until the BLUE indicator lights.
Switching the unit off:
› Press and hold both “Music” and “AUX” buttons together
for approximately 3 seconds until the RED indicator flashes
3 times.
Pairing with Bluetooth devices
Your Midland BT Rebel is a Bluetooth unit that can be paired
with other Bluetooth devices.
Before performing this procedure, it is necessary to set BT
Rebel into “Pairing mode” (Setup).
The only operations permitted in this mode are the pairing
ones. To use the BT Rebel unit after pairing it with the desired
devices, it is necessary to quit the “Setup” mode and switch to
the “Operating” mode.
Setup mode
Switch off the BT Rebel device. Press and hold down the cen-
tral button (Music/on) for about 7 sec. until the red indicator
switches on permanently. BT Rebel is now in “Setup” mode
and can therefore be paired with other devices.
Pairing the unit with your cell phone
1. Enable the Bluetooth device search feature on your cell
phone. As this procedure varies according to the brand and
model of the cell phone, refer to the manual supplied to
your particular phone for further information.
2. Set the BT Rebel unit in “Setup” mode, then press the
“Phone” button on the unit until the red and blue indicators
start flashing.
3. After a few seconds the cell phone will display “Midland BT
Single”. Select it and follow the instructions provided in your
cell phone manual to accept the pairing. When prompted,
enter the pairing code, which is 0000 (four zeroes). Your
cell phone should then display a confirmation message if
the pairing operation has been successfully completed (In
case of error message, complete anyway the procedure,
exit the “setup” mode and try to use the BT Rebel with your
phone).
4 The BT Rebel unit returns to the Setup mode (red indicator
permanently on) to indicate that it is ready to be paired with
other devices
If you pair the BT Rebel unit with a cell phone, you will not be
able to pair it with a GPS Sat-Nav, because both these devices
are assigned (high) priority 1.
This problem can be easily solved by pairing your cell pho-
ne directly with your GPS Sat-Nav and then pairing the GPS
with your Midland BT Rebel using the above procedure. In this
case, the cell phone features will be managed by the GPS
Sat-Nav.
Pairing the unit with a GPS Sat-Nav
It is generally possible to pair the BT Rebel unit with all GPS
Sat-Navs that support Bluetooth earpieces.
Midland BT Rebel has been successfully tested for use with
GPS ZUMO Sat-Navs manufactured by Garmin and TOMTOM
Rider 1 and 2 Sat-Navs.
1. On your GPS Sat-Nav, enable the Bluetooth earphone
search feature. As this procedure varies according to the
brand and model of GPS, we recommend you refer to the