MIDLAND BT Rebel - Manual (Page 3)

3
E
n
g
li
s
h
Midland BT Rebel
Thank you for choosing MIDLAND BT Rebel, the wireless multimedia system for bikers.
MIDLAND BT Rebel has been designed to be fitted on your helmet and to be used for communicating with Bluetooth devices such
as cell phones or GPS navigators.
MIDLAND BT Rebel is also equipped with a wired connection to connect an iPod/MP3 play or GMRS transceiver for bike-to-bike
communications up to a maximum distance of 3 miles.
Technical specifications
of Midland BT Rebel
General:
› Bluetooth ver. 2.0 stereo (Headset/Handsfree/A2DP proto-
col)
› AGC system automatically controls the volume in relation
to background noise
› Voice (VOX) or manual call option
› Fully waterproof
› Lithium battery with 8 hours talk time (up to 2 days in stan-
dby mode)
› Recharge time: app. 4 hours
› Dimensions. Length: 87 mm – Width: 47 mm - Thickness:
16 mm
Bluetooth connections:
Cell phone, GPS (Garmin Zumo and TomTom Rider 1 and
2)
Wire connections:
› For stereo audio input (iPod/MP3 player)
› For GMRS transceivers (with optional cable)
Attention: before using BT Rebel for the first time, re-
member to recharge it for at least 4 hours.
Attention: Midland BT Rebel is designed to withstand
rain and water. However, if it is raining, always verify that
the rubber caps protecting the sockets are fully fitted.
›
Charging batteries
Make sure that the unit is fully charged before use. Allow at
least 5-6 hours for a full charge before using the unit for the
first time. Normally, after the first time, it takes 4 hours for a
full charge.
Charge the unit by inserting the wall-charger into the charging
socket (lift the rubber cover to insert the plug).
› The red LED on the unit will start flashing when charging
begins.
› Allow the headset to charge until the red LED turns off.
› When the charge is complete, release the headset from
the charger.