MIDLAND BT2 User Manual

Page 5

Description of the audio kit

The audio system includes two ultra-flat stereo speakers and

two interchangeable microphones, which are both supplied

with a bracket and wire connection.

Fixing the stereo speakers. The two stereo speakers have a

Velcro/adhesive strip that aids their fixing to your helmet.

Beware to not completely cover your ear with the speakers,

you must always be able to listen to the traffic sound and in-

dication.

The microphone can be fixed onto the helmet in two ways:

Boom Microphone. Place the section with the Velcro/adhesi-

ve strip between the padding and the rigid cover of the helmet,

so that the microphone is correctly positioned in front of your

mouth and that the white symbol is facing your mouth. This

type of microphone is suited for Open Faced and Flip Front

helmets.

Wire microphone. Using the Velcro/adhesive strip, place the

microphone inside the helmet in front of your mouth. This type

of microphone is more suited for Full Faced helmets. The mini

connector on the microphone allows you choose the micro-

phone that best suits the helmet you are using.

The audio kit must then be connected to the central jack of the

Midland BT2 Intercom unit using the “L” shaped connector.

This connector is very flexible and can be easily adapted to

most commercial helmets.

Description of the installation brackets

The Midland BT2 can be fixed onto the helmet in two different

ways: By either using the plate with bi-adhesive strip, or the

clamp. These methods allow you to safely “fix” the BT2 unit

onto your helmet and to remove it at any time in order to re-

charge or store it.

Plate with bi-adhesive strip

The fixing plate has a bi-adhesive strip on one of its sides. To

fix the plate in place, clean the application area on the helmet

surface, remove the bi-adhesive film and place the fixing plate

on the helmet by keeping it contact with the surface for a few

seconds.

Clamp

Using the Allen Key, loosen the

two screws on the clamp and

place the rear plate between the

helmet padding and the external

rigid protection. Then, tighten the

two screws in order to firmly fix the

clamp in place.

Fitting and removing your Midland BT2

The BT2 can be easily fitted onto the helmet by sliding it down-

wards so that it fits into the slot of the selected fixing device

(plate with bi-adhesive strip or clamp).

BT2 is maintained in position thanks to the fixing clip located

on the upper section (A).

To detach the BT2, simply press the fixing clip and push the

unit upwards.