Luminex 100 IS User Manual Addendum Version 2.3 - Manual (Page 4)

Addendum to User Manual Version 2.3
x
MAP Technology
2 PN 89-00002-00-140 Rev. A
Safety and
Regulatory Symbols
New safety and regulatory symbols have been added to the Luminex
100 system and manuals. Please become familiar with these symbols.
These symbols describe warnings, cautions, and general information
used in the operation of this instrument.
Calibrators and
Controls
Vortex the xMAP calibrators and controls containers to ensure
homogeneity. Do not dilute xMAP calibrator and control reagents.
Note that position of the vial may affect drop size. Be sure to invert
the vial such that it is perpendicular to the plate surface. When
calibrating the analyzer, load a microtiter plate with at least five
drops of each: CAL1 in well A1, CAL2 in well B1, CON1 in well
C1, CON2 in well D1 and distilled water in well E1 through H1 to
Wash a total of four times. You can use different wells as necessary.
To select different well locations in the software, click on the drop-
down arrow next to the entry cell for the calibrator or control, then
click in the well location on the microtiter plate image.
Symbol Description Symbol Description Symbol Description
Alternating current
(ac)
Warning
(refer to manual) Warning
(refer to manual)
Protective ground
Warning
(refer to manual) Warning
(refer to manual)
On
Warning
(refer to manual) Warning (refer to
manual)
Off
Catalog Number Consult instructions
for use
In vitro Diagnostic
Medical Device Batch Code Serial Number
Temperature
Limitation
Expiration Date Date of Manufacture
Manufacturer
Underwriter’s
Laboratory Canadian
Underwriter’s
Laboratory
European Union
Conformity WEEE - Do not
throw in trash
US