Luminex 100 IS 2.3 User Installation Guide - Manual (Page 9)

x
MAP Technology Luminex 100 IS System Specifications
PN 89-00002-00-028 Rev. B 9
• Reservoir
• Shield
• Heater block
• Sheath fluid container
• Waste container
• Sheath fluid line
• Air line
• Sheath fluid intake line
• Communications: 1 serial communication cable
• Communications: 1 USB communication cable
(PN 85-10011-00-046)
• Communications: 1 CAN bus communication cable
(PN 85-10011-00-068)
• Barcode reader
• Sample probe height alignment kit
• 3/32 Hexdrive, Balldriver wrench
© LUMINEX CORPORATION, 2004. All rights reserved. No part of this publication may be reproduced,
transmitted, transcribed, or translated into any language or computer language, in any form or by any means
without prior express, written consent of:
LUMINEX CORPORATION Voice: (512) 219-8020 PN 89-00002-00-028 Rev B
12212 Technology Boulevard Fax: (512) 219-5195
Austin, Texas 78727-6115
U.S.A.
Luminex Corporation (“Luminex”) reserves the right to modify its products and services at any time.
This guide is subject to change without notice. Although prepared to ensure accuracy, Luminex
assumes no liability for errors or omissions, or for any damages resulting from the application or use
of this information.
The following are trademarks of Luminex Corporation: Luminex, Luminex 100, Luminex 100 IS,
LabMAP, LumAvidin, Spectral Address, Luminex HTS, Luminex SD, Luminex XYP, xMAP, Luminex
SeroMAP,and Luminex FlexMAP. All other trademarks, including Windows, Cheminert, Tween,
Pentium, and Dell.