Magnum Venus Plastech DuraMAX Gun DMX-3000 - Manual (Page 28)

DuraMAX Gun Manual
Rev. 12/2012 Page | 28
General Problems
1. Material leaking from around the mix chamber
— Replace Mix Housing Seal (O-S-018)
— Replace Catalyst Injector Seal (5104-13-1)
2. Air leaking from around poppet needle
— Tighten Retainer (54420-1) (caution do not over tighten, this will make the poppet
needle move slowly or not move at all.)
— Replace O-Ring (O-S-104A)
3. Air leaking from around poppet valve body
— Tighten Poppet Valve Body (54440-1) into Gun Handle (54350-3)
4. Air leaking from fitting on handle or to chopper
— Retainer (54420-1) may be too tight and holding valve open
— Check Poppet Assembly (MG-2031) for wear or damage
— Check Poppet Valve Body (54440-1) seat area for ware or damage
5. Material leaking from around nozzle or nozzle cap
— Tighten Nozzle Cap (8704-4-1) (caution do not over tighten or you may damage
the Turbulent Mixer (5107-27-3) Hand tighten only
— Check Turbulent Mixer (5107-27-3) for damage or ware
— Check front of Mix Housing (MAX-2017-T) for damage
6. Trigger Action stiff or hard
— Check Trigger (54360-1) for damage
— Check Trigger Stud (54630-1) and Screw (00145) for damage, remove and
lubricate as needed.
— Check Needle Guides (53900-1) and Springs (04039-1) for damage, remove and
lubricate as needed
— Check Spring Retainer (54000-1) for ware or damage
— Check Needles and Needle Housings for hardened or sticky material