Magnum Venus Plastech Gel Coat Gun EMG-1500 - Manual (Page 13)

AIR PRESSURES
1. Air requirement recommendations:
a. A minimum of 100 psi on main air.
b. 20 - 30 CFM for chopper systems
2. Material pump: 30 - 50 psi
TESTING SPRAY PATTERN
1.
Testing of your spray pattern should be performed away from original part. Use
paper or cardboard to check the following:
(see “Testing & Adjusting Manual”)
2.
Spray pattern width and output
3.
Catalyzation
4.
Spray pattern definition (fingers and tails):
5.
Adjust as necessary with the “MVP Air Assist” adjustment screw to give the finest
pattern available by eliminating fingers and tails.
After completion of the above procedures, you may now confidently use your
MVP system