Magnum Venus Plastech RT-4000 RTM INJECTOR TRIGGER - Manual (Page 16)

RT-4000 Remote Trigger Manual
Rev. 12/2012 Page | 16
Making Connections:
To make the connections disassemble the connector plug attached to the side of the
control box. Use 1/4 inch poly tube, MVP number 01417 and Hose Clamp 7701-2-1 to
make connections between the connector plug and component. Connections are made
by sliding the Hose Clamp onto the correct poly tube pushing the poly tube onto the
correct barb fitting and thread the Hose Clamp over the poly tube and barb fitting. It is a
good idea to mark both ends of each piece of tubing to aid in trouble shooting and
plumbing.
The RT-4000 is a modular system and for this manual it will show how to make all
connections. If the connection to the valve or the Gun are not going to be used you
must plug the “OFF” signals. This can be done by attaching a short piece of poly tube
to correct port and folding it over (kink) then tape it to itself, or plugging it with
something. The “ON” signals or other components will only blow air if they are pushed,
but can be plugged as desired by following the process mentioned above.
Below is a diagram of the signal connections for the RT-4000 RTM Injector Trigger.
It is best to organize and plan the routing of the tubing as it is installed to make the
installation easier and look better. Use plastic ties or tape to pair similar tubing and
control the tubing bundle.