Magnum Venus Plastech Pro Series PCP-2000 - Manual (Page 17)

PCP-2000 Catalyst Pump Manual
Rev. 05/2012 Page | 17
k. Connect the ¼-inch poly line to the relief valve on the catalyst manifold assembly and
insert the other end into the hole in the top of the catalyst jug.
l. Connect the ¼-inch poly line to the catalyst recirculation valve on the catalyst manifold,
and insert the other end into the hole in the top of the catalyst jug.
7. Check all components and hoses for damage.
8. Check and tighten all fittings.
9. Check resin filter – apply red grease to the filter cap threads and o-ring reinstall. Do not
over tighten.
10. Check resin surge chamber – apply red grease to o-ring and nipple threads and reinstall
surge chamber hand tight.
Maintenance
 At least every six months, completely disassemble and inspect the catalyst pump
assembly. Replace the S.S. balls, O-Rings, springs, piston seal and packing
assembly.

Snug / tighten the Metering pump packing nut approximately 1/8 – 1/4 turn
clockwise to prevent leakage. Repeat this procedure when necessary to
prevent material from leaking. Do not over tighten as this will reduce the
life of the packing set and may cause damage to the pump.
Troubleshooting
 The catalyst system should be checked if you are experiencing an uneven cure
or slow gel time.

For a complete troubleshooting guide, please refer to the manual “Testing &
Adjusting Your MVP Pumping System” containing important testing procedures
that should be performed every time the catalyst pump is serviced.