Magnum Venus Plastech MicroPro - Manual (Page 15)

MicroPro Operations Manual
Rev. 09/2012 Page | 15
Introduction:
The MicroPro proportioner uses an air driven Powerhead to drive the metering system,
which delivers a consistent mix / meter at low flow rates. The system can be configured
in ratios from 1:1 to 3.7:1, 1.84:1 to 5.85:1 and 4.15:1 to 13:1 using a combination of
metering pumps.
This manual provides information needed to properly operate and perform simple
maintenance and repair on this equipment.
Step-by-step operations procedures are provided.
This manual includes Installation, Start-up and Shut-Down instructions.
Step-by-step assembly and disassembly procedures are included for each
component.
Please read this manual carefully. Follow the steps in the order given, otherwise you
may damage the equipment or injure yourself.
Component Assemblies:
The MicroPro proportioner consists of a combination of two of the following metering
pumps and other components:
1:1 Classic Pro Gun Repair Manual
MPR-PH-3250 3.25” Powerhead Assembly – MicroPro 10:1
or
MPR-PH-5000 5” Powerhead Assembly – MicroPro
VHPC-1200 Metering Pump
Depending on unit configuration on of the following:
VHPC-2200 Metering Pump
VHPC-3200 Metering Pump
VHPC-4200 Metering Pump