Magnum Venus Plastech UltraMAX MULTI–COLOR GELCOATER MVE-1400-X-1 - Manual (Page 15)

UltraMax Multi-Color Gelcoater Manual
Rev. 03/2013 Page | 15
3.2 Grounding
Grounding an object means providing an adequate path for the flow of the electrical charge from
the object to the ground. An adequate path is one that permits a charge to flow from the object
fast enough that it will not accumulate to the extent that a spark can be formed. It is not possible
to define exactly what will be an adequate path under all conditions since it depends on many
variables. In any event, the grounding means should have the lowest possible electrical
resistance. Grounding straps should be installed on all loose conductive objects in the spraying
area. This includes material containers and equipment. Magnum Venus Plastech recommends
grounding straps be made of AWG No.18 stranded wire as a minimum and the larger wire be
used where possible. NFPA Bulletin No77 states that the electrical resistance of such a
leakage path may be as low as 1 meg ohm (10 ohms) but that resistance as high as 10,000
meg ohms will produce an adequate leakage path in some cases. Whenever flammable or
combustible liquids are transferred from one container to another, or from one container to the
equipment, both containers or container and equipment shall be effectively bonded and
grounded to dissipate static electricity. For further information, see National Fire Protection
Association ( NFPA) 77, titled “Recommended Practice on Static Electrical”. Refer especially to
section 7-7 titled “Spray Application of Flammable and Combustible Materials”. Check with local
codes and authorities for other specific standards that might apply to your application. NEVER
USE HARD MATERIALS SUCH AS WIRE, PINS, ETC., TO CLEAR A PLUGGED GUN. HARD
MATERIALS CAN CAUSE PERMANENT DAMAGE. DAB WITH A BRISTLE BRUSH, BLOW
BACKWARDS WITH AIR UNTIL CLEAR WHILE WEARING A PROTECTIVE EYE SHIELD.
REPEAT AS MANY TIMES AS NECESSARY. DO NOT PERFORM ANY MAINTENANCE OR
REPAIRS UNTIL YOU HAVE FOLLOWED THE PRECAUTIONS STATED ABOVE. IF YOU, AS
AN EQUIPMENT OPERATOR OR SUPERVISOR, DO NOT FEEL THAT YOU HAVE BEEN
ADEQUATELY TRAINED OR INSTRUCTED AND THAT YOU LACK THE TECHNICAL
KNOWLEDGE TO OPERATE OR PERFORM MAINTENANCE ON A PIECE OF MAGNUM
VENUS PLASTECH EQUIPMENT, PLEASE CALL MAGNUM VENUS PLASTECH BEFORE
OPERATING OR PERFORMING MAINTENANCE ON THE EQUIPMENT. IF YOU HAVE ANY
QUESTIONS REGARDING THE ABOVE PRECAUTIONS OR ANY SERVICE OR OPERATION
PRECEDURES, CALL YOUR MAGNUM VENUS PLASTECH DISTRIBUTOR OR MAGNUM
VENUS PLASTECH.
NOTICE: All statements, information and data given herein are believed to be accurate
and reliable but are presented without guaranty, warranty or responsibility of any kind
express or implied. The user should not assume that all safety measures are indicated
or that other measures are not required.
DANGER: Contaminated catalyst may cause Fire or Explosion. Before working on the
catalyst pump or catalyst accumulator, wash hands and tools thoroughly. Be sure work
area is free of dirt, grease or resin. Clean catalyst system components with clean water
only.
DANGER: Eye, skin and respiration hazard. The Catalyst, MEKP, may cause
blindness, skin irritation or breathing difficulty. Keep hands away from face.
Keep food and drink away from work area.
WARNING: Please refer to your catalyst manufacturer’s safety information
regarding the safe handling and storage of catalyst. Wear appropriate safety
equipment as recommended.