Magnum Venus Plastech UltraMAX VHPC-1000 Series - Manual (Page 15)

VHPC-1000 Metering Pump Manual
Rev. 05/2012 Page | 15
Introduction:
This manual, the VHPC-1000 Metering Pump Manual, provides information you need
to perform simple maintenance and repair on your equipment.
Step-by-step assembly and disassembly procedures are included for each
component.
Please read the manual carefully. Follow the steps in the order given, otherwise you
may damage the equipment or injure yourself.
DANGER: Always wear proper safety equipment, including eye protection and
gloves when performing service and repair on this equipment.
During Disassembly:
As you disassemble the equipment, lay out the components on a clean surface in the
correct order and direction. This will help you to reassemble them.
This manual covers the following Metering Pump Assemblies:
VHPC-1000
Metering Pump Assembly
VHPC-1000-C-3J Metering Pump Assembly – Check Valve
VHPC-1000-C-UPS Metering Pump Assembly – Check Valve – Suction Feed
VHPC-1000-RV-INT Metering Pump Assembly – Relief Valve – International
VHPC-7200-C-3J Metering Pump Assembly – Slave Arm
PHPC-7200-B Metering Pump Assembly – Putty Units - BPO
PHPC-7200-M Metering Pump Assembly – Putty Units - MEKP
Note: Some parts and part numbers will be different between the different
Metering Pump Assemblies – it is important to have a current parts drawing for
the Pump assembly you are working on.
Tools Required
1. 1” Open End Wrench (08378)
2. 3/4” Open End Wrench (08474)
3. 5/8” Open End Wrench (08474)
4. 6” Adjustable Wrench (2 required) (08466)
5. 12” Adjustable Wrench (08468)
6. 1/4” Wood Dowel – 6” long