Magnum Venus Plastech PATRIOT 10 PAT-PH-10000 - Manual (Page 23)

Patriot Powerhead Manual PAT-PH-10000
Rev. 10/2012 Page | 23
Air Cylinder Assembly:
NOTE: Have a current drawing for the Powerhead you are working on to reference
for part numbers.
1. Apply a thin coat of brown grease to the inner bore of the Lower End Cap (PAT-
PH-10004) and install the Lower Bushing (VPH-7005).
2.
Install snap ring to secure the Lower Bushing in place.
3. Apply a thin coat of brown grease to the inner bore of the Upper End Cap (PAT-
PH-10012) and install the Upper Bushing.
4.
Install Snap Ring (7205-2-26) to secure the Upper Bushing in place.
5.
Insert the Lower Rod through the Piston Rod Bushing of the Lower End Cap.
6.
Slide the Cylinder (PAT-PH-10003) over the Piston (VPH-10006) down onto the
Lower End Cap O-ring (O-B-167).
NOTE: Use caution not to damage the O-ring in the Upper Bushing when
installing the Upper End Cap over the Upper Rod.
7. Set the Upper End Cap (PAT-PH-10012) onto the Cylinder with the valve block
flats facing the same direction. Screw the Hex Nuts (F-HN-06F) onto the Tie
Rods and snug the Hex Nuts. See bolt torque procedures section of this
manual for details.
8. Lift the Shell Retainer (PAT-PA-9110) up and Install the two Half Shells (VPH-
10009) to the end of both rod buttons. Install Sleeve Clip (PAT-PH-9112) to the
Lower Rod (PAT-PH-10009).
9. Connect the pilot air hose and regulated air hose to air motor.
10. Install the Muffler using the two Hex Head Cap Screws (F-HB-04C-56-SS).