Mach III Clutch T6H1G-STL, T6H1H-STL, T6H2H-STL - Manual (Page 5)

7/9/2013 TORQLIM_FLEXCOUPL_MANUAL Page 5 of 5
B. Product Numbers: T6H1G-STL, T6H1H-STL, T6H2H-STL and non-catalog
variations of this torque limiter design.
(1) Make sure the adjustment nut (REF. A) is snug against the disc spring (REF. B).
(2) Make sure the six jam nuts (REF. C) mounted on the six set screws (REF. D) which are placed axially
in adjustment nut (REF. A) are loose.
(3) Screw the six set screws (REF. D) in the adjustment nut (REF. A) until they contact the disc spring
(REF. B).
(4) Using a circular pattern, tighten the six set screws (REF. D) in the adjustment nut (REF. A) one 1/4-
turn each.
NOTE: If needed, fine tune the torque value of the unit in 1/8-turn increments of the six set screws
(REF. D).
(5) Check torque value after each 1/4-turn increment of all six set screws (REF. D) while holding
adapter/sleeve (REF. F) stationary and turning drive hub (REF. G) with a torque wrench.
NOTE: A torque wrench with a multiplier may be needed for higher torque settings.
(6) Once desired torque is reached, confirm each of the six set screws (REF. D) are in contact with the
disc spring (REF. B).
(7) Tighten the jam nuts (REF. C) mounted on the six set screws (REF. D) firmly against the adjustment
nut (REF. A).
(8) Tighten the nylon-tipped set screw (REF. E) in the outside diameter of the adjustment (REF. A).
Technical assistance is available by contacting Mach III Clutch, Inc.
Mach III Product Warranty
http://www.machiii.com/Resources/Warranty-Info.asp
Mach III Clutch, Inc.
101 Cummings Drive ● Walton, KY 41094
Toll free 866.291.0849 ● International 859.291.0849 ● Fax 859.655.8362
[email protected] ● [email protected] ● www.machiii.com
A
B
C
D
E
F
G