Mach III Clutch T6H1G-STL, T6H1H-STL, T6H2H-STL - Manual (Page 3)

7/9/2013 TORQLIM_FLEXCOUPL_MANUAL Page 3 of 5
SET SCREW
SET SCREW
DRIVE DISCS
FRICTION DISCS
SPRING
SET SCREW
NUT
ELASTOMERIC ELEMENT
COUPLING
SET SCREWS
W/JAM NUT (some models)
IV. Routine Maintenance
When installed and operated according to the preceding guidelines, Mach III Clutch products
should require little or no routine maintenance. A repair kit is available which contains all
parts subject to typical wear: friction discs, springs.
V. Parts Diagram
Kits Available Contents Part Numbers
Facing Kit Friction Disc T3H2H-STL-FCGK, T4H2H-STL-FCGK, Etc. . . .
Repair Kit Friction Disc, Spring(s) T3H2H-STL-RPRK, T4H2H-STL-RPRK, Etc. . . .
For part numbers of components not included in the kits above, please contact Mach III Clutch,
Inc. or your distributor. Factory repair is also available. A return materials authorization (RMA)
number must be obtained prior to sending any unit in for repair. Mach III Clutch is not
responsible for products returned without authorization.
VI. Repair Kit Installation Procedure
A. DISASSEMBLY
Loosen set screws using appropriate hex wrench and slide the clutch off of the shaft. Place the
clutch on a work surface with the adjustment nut facing upward. Loosen the set screw in the
adjustment nut and set screws and jam nuts (some models) and remove nut using a wrench or
channel lock pliers. The spring, drive discs and friction discs can now be removed.
Tools Needed
Hex wrench set
Retainer (snap) ring pliers
Spanner Wrench
Compounds Required
Anti-Seize Lubricant