Specifications – Lectrosonics EQ1_EQ2 User Manual

Page 9

27 Band Automatic Equalizer

SPECIFICATIONS

EQ In:

Balanced, RF protected, 40k Ohm impedance

Ref Mic In:

Balanced, RF protected, 1.5k Ohm impedance
+15V phantom power (always present)

Thru Out:

Parallel to EQ In, provides a pre-EQ output

Main Out:

Balanced, 200 Ohm output impedance

EQ Type:

27 band, 1/3 octave, on ISO centers from 40Hz to 16kHz

Filter Type:

Constant-Q, ±3% center frequency accuracy

Cut/Boost Range:

±15dB

Low Cut Filter:

200Hz, 6dB/octave

Pop Suppression Filter (DPS):

Dynamic high-pass, maximum filter corner frequency is 1kHz,
6dB/octave. Threshold range at 100Hz is -40dBu to 0dBu.

Noise (20Hz to 20kHz)

All controls flat:

-95dBu

All controls +12dB:

-68dBu

All controls -12dB:

-82dBu

THD:

Less than 0.08% (20Hz to 20kHz, +4dBu in)

Frequency Response:

+0/-3dB, controls flat, 20Hz to 70kHz

Maximum Levels

Input:

+22dBu, controls flat

Output:

+22dBu, controls flat

Specifications subject to change without notice.

Rio Rancho, NM – USA