Lectrosonics EQ1_EQ2 User Manual

Page 15

27 Band Automatic Equalizer

Set Input Source - Allows the EQ1 input source to be set.

Host sends command - 16
Host sends 2 bytes:

Byte 1: 0 - Change current setting

1 - User Target Curve 1
2 - User Target Curve 2
3 - User Target Curve 3

Byte 2: 0 - EQ In, 1 - Ref Mic In

Host receives 1 byte: 100 to confirm

Output Output Source - Outputs the current output source, EQ Out or Noise Out.

Host sends command - 17
Host receives 1 byte: 0 - EQ Out is source, 1 - Noise Out is source

Set Output Source - Allows the EQ1 output source to be set.

Host sends command - 18
Host sends 1 byte: 0 - EQ Out is source, 1 - Noise Out is source

Low Cut Filter Commands

Output Lowcut Filter - Outputs the current state of the Lowcut filter.

Host sends command - 19
Host receives 1 byte: 0 - Lowcut out, 1 - Lowcut in

Set Lowcut Filter - Allows the state of the Lowcut filter to be set. Byte 1 is the Lowcut Filter setting (0-Out, 1-In).
Byte 2 is 0 or 1, and indicates whether or not to save the new value to EEPROM.

Host sends command - 20
Host sends 2 bytes: Byte 1: 0 - Lowcut Out, 1 - Lowcut In; Byte 2: 1 - Save to EEPROM, 0 - don’t
Host receives 1 byte: 100 to confirm.

Rio Rancho, NM – USA