Lectrosonics UCR411a - Manual (Page 11)

UHF Digital Hybrid Wireless™ Receiver
Rio Rancho, NM 11
From the Main window, you can navigate to the Fre-
quency, Battery Level and Setup windows in a circular
sequence by pressing the MENU button.
Frequency Window
TVxx - Indicates the television broad-
cast channel (xx) this frequency falls
within.
Transmitter switch settings (AE in the illustration)
-These are the correct switch settings for the frequency
switches on your transmitter - see your transmitter
instructions.
Frequency - Press the SEL Up and Down buttons to
change the frequency of the receiver.
Note: Be certain to change the transmitter
frequency switches to match the settings shown
in the upper left hand corner of the Frequency
window.
Menu Selections from Main Window
When the TUNING mode is set to NORMAL, the SEL
Up and Down buttons tune in single channel incre-
ments. In the group tuning modes, the SEL Up and
Down buttons move among the selected intermod-free
frequencies.
Tuning shortcuts: In NORMAL tuning mode, MENU+UP
and MENU+DOWN tune in 16 channel increments for
faster tuning. In the group tuning modes, MENU+UP
jumps to the first frequency in the group and
MENU+DOWN jumps to the last one in the group.
Battery Level Window
This window shows the transmit-
ter (TX) and receiver (RX) battery
voltage. These levels will flash when
there will be about one hour operating time remain-
ing. The RX voltage changes to EX when operating on
external power and displays the external power source
voltage. (Disclaimer: We cannot guarantee 0.1 Volt ac-
curacy.)
Note: NA M7 & EU M7 are only
available with firmware 6.0 on the
audio board.