AEG EXTRACTORHOOD 125 D - Manual (Page 17)

17
Something not working
If your cooker hood fails to work properly please carry out the following
checks.
Sympton Solution
The cooker hood will not start... The hood is connected to the
electricity supply.
Check that the fan speed control is
set to 1, 2 or 3.
The cooker hood is not working The fan speed is set high enough
effectively... for the task.
The grease filter is clean.
The kitchen is adequately vented to
allow the entry of fresh air.
If set up for recirculation, check that
the charcoal filter is still effective.
If set up for extraction, check that
the ducting and outlets are not
blocked.
The cooker hood has switched off The safety cut-out service has been
during operation... tripped.
Turn off the hob and then wait for the
device to reset.
If after all these checks, the problem persists, contact your local Service
Force Centre, quoting the model and serial number.
Please note that it will be necessary to provide proof of purchase for any in-
guarantee service calls.
In-guarantee customers should ensure that the above checks have been
made as the engineer will make a charge if the fault is not a mechanical or
electrical breakdown.