Controlled Products Systems Group DIALCODE - Manual (Page 26)

Repeat steps 7 and 8 for up to ten devices per directory code. After the last device has been programmed,
press or key to return to the program selection screen.
TRANSMITTER/CARD PROGRAMMING
25
LC/VF Page
STEP
6
005 TRANSM/CARD#1:
___-_____ (S) SCAN
To complete entry, press the key to return to the program selection screen.
To program RF devices ( i.e. transmitters/cards etc.) continue on to Step 7.
NOTE: To enable the transmitter/card programming feature, you must insert the communicator card
in the “backup” slot before you turn on unit. (refer to “Memory Card Installation” section)
005 TRANSM/CARD#2:
___-_____ (S) SCAN
005 TRANSM/CARD#10:
___-_____ (S) SCAN
•
•
•
•
STEP 7
STEP
9
NOTE: The time zones and restrictions associated with transmitter/card codes can only be programmed remotely using the
EMS modem software.
STEP 8
C V B N M ’ X Z
A
Q W E R T Y U I
0
7
4
1 2 3
5 6
8 9
O P
S D F G H J K L
SPACE BAR
EX T HELP PROGRAM ERASE ENTER
BACK SPACE
SHIFT
STAND-ALONE
RECEIVER
Model ERRB485
Processor
Touch the card to the card reader
to activate remote device
Model ECR485B
Press button on transmitter to activate remote device
(fig a.)
(fig b.)
Use keys to view and
program up to 10 transmitter or card
codes associated to the directory code.
To program a transmitter or card code
you may enter the code manually using
the keypad or you may scan the
transmitter/card code.
To scan a card code, press and release
the key and activate the card
as shown in fig a.
To scan a transmitter code, press and
release the key and activate
the transmitter as shown in fig b.
S
S