Controlled Products Systems Group MWCK04 - Manual (Page 4)

The Communicator II
Wireless Transmitter Wiring Diagram
MILLER EDGE, INC. • P.O. Box 159 • West Grove, PA 19390 • 610-869-4422 • Fax: 610-869-4423 • 1-800-220-3343 • www.milleredge.com
MILLER EDGE, INC. • 6809 South Harl Avenue • Suite A • Tempe, AZ 85283 • 480-755-3565 • Fax: 480-755-3558 • 1-800-887-3343
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radi-
ate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communi-
cations. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which may be determined by turning the equipment off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
1- Re-orient or relocate the receiving antenna
2- Increase the separation between the equipment and receiver
3- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
4- Consult the dealer or an experienced radio/TV technician for help.
Any user that changes or makes modifications not expressly approved by Miller Edge Inc.
could void the user’s authority to operate the equipment.
IMPORTANT
Part # 400-MW-002
Rev. 002 / 8-18-10
U.S. Patent # 7,123,144