Controlled Products Systems Group 8055-081 - Manual (Page 2)

Programming
8055-065-B-8-11 Copyright 2011 DoorKing, Inc. All rights reserved.
Programming Transmitter Codes: Press and hold the programming push button (about 2 seconds) until the programming LED quickly
flashes ONE time, then release the button. The programming LED will flash once every two seconds indicating that you are in the transmitter
programming mode....
....While the programming LED is flashing, activate each of the MicroPLUS ® transmitters that will be used (If you are using a two or three button
transmitter, make sure to press the correct button). A maximum of 40 transmitters codes can be stored in this receiver.
Once the desired transmitter codes have been stored into the receiver memory, the receiver will automatically exit the programming mode when no
more transmitter codes are received (approx. 30 seconds idle time). This will be indicated by a series of 10 quick flashes followed by a long flash.
Erase All Transmitter Codes: Press and hold the programming push button until the programming LED quickly flashes ONCE, then TWICE,
then THREE times, then FOUR times for three times in a row (about 12 seconds total for the whole sequence), then release the button. Five
seconds after releasing the button, the LED will emit ONE long flash indicating ALL memory (transmitter codes) have been erased.
120 Glasgow Avenue
Inglewood, California 90301 U.S.A.
This device complies with the FCC Rules Part 15. Operation is subject to the following two conditions:
1.) This device may not cause harmful interference.
2.) This device must accept and interference received, including interference that may cause undesired operation.
This class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Réglement sur le matériel brouilleur du Canada.
Twice Three Times Four Times Four Times
Three Times in a Row
Four Times One
Long
Flash
One
Long
Flash
10 Quick Flashes
5 Sec. Release
Button
Release
Button
Once
One Quick Flash
2 Sec.
Press
and
Hold
Button
Press
and
Hold
Button
2 Sec. 2 Sec. 2 Sec. 2 Sec. 2 Sec.
Transmitter Programming Mode
Activate All Desired
MicroPLUS
® Transmitters
All Desired
MicroPLUS ® Transmitters
have been Activated
2 Sec. 2 Sec. 2 Sec.
Transmitter Programming Mode
Approximately 30 Seconds Idle Time
Approximately 12 Seconds
DoorKing Part Numbers
8055-080
Built-In Antenna
8055-081
Coax Antenna Kit
1 2
3
Programming Push Button
Programming LED
FINISH
START